Craftsman 536.797500 - Manual (Page 6)

AQQPiiRI Y
|L-, pMi d i— I
A CAUTION; ALWAYS WEAR SAFETY
GLASSES OR EYE SHIELDS WHILE
ASSEMBLING TILLER/ MINI TILLER/
CULTIVATOR.
TOOLS REQUIRED FOR ASSEMBLY
1 - 5 / 1 6 inch Wrench {or adjustable wrench)
2 - 7/16 inch Wrenches (or adjustable wrenches)
1 ' Regular Screwdriver
1 - Pair Scissors
1 ' Hammer
Figure 1 shows the mini tiller/cultivator completely
assembled
Reference to the right and let! hand side of the mini tiller/
cultivator is from the operator’s position behind the unit
TO REMOVE MINI TILLER/CULTIVA­
TOR FROM CARTON
# Remove the piastic parts bag from the carton
® Remove the handles 1rom the carton
® Remove packing insert trom carton that contains
depth stake/transport wheels assembly
® Lift the tiller/mini tiller/cultivator out of the carton and
place on a hard level surface
® Remove packing material from around tines
TO INSTALL THE HANDLE
ASSEMBLY
The lower handles have a short bend at the bottom end
arid are flattened at the top to allow the upper handle to
be placed between the lower handles To assemble the
handles, do the following:
® Unwind the throttle control from around the engine
and straighten the cable Be careful you do not kink
the cable.
® Remove two iocknuts, four washers and two handle
mounting screws from the tine shield (see Fig 2)