Craftsman 358.351080 - Manual (Page 9)

OPERATION
HOWTO USE YOUR CHAIN SAW
STOPPING YOUR ENGINE
• Move on/stop switch to the "Stop" positron.
• If engine does not slop, pull blue choke knob out fully.
CHAIN OILER {Fig. 7)
• The chain oiler provides continuous lubrication to the
chain and guide bar. Be sure to fill the bar oil tank when
you till the fuel tank (Capacity 6.8 fl, oz.).
• Your chain saw will consume approximately one tank of
bar oil for each tank of fuel used.
Your chain oiler is automatic and requires no adjustment.
THROTTLE CONTROL GROUP (Fig. 8)
THROTTLE LOCKOUT
• The throttle lockout prevents unintentional actuation of
the throttle trigger.
• You must depress the throttle lockout with the palm of
your hand before actuating the throttle trigger,
THROTTLE TRIGGER
• The throttle trigger allows for varicdsle control of engine
speed.
• The throttle trigger is actuated by the index finger on your
right hand. (After the throttle lodcout is depressed).
CHOKE/FAST IDLE SPEED
• The choke and fast idle speed are set by pulling the
choke lever out fully for cold or refueled engine starts.
• Squeezing the throttle trigger will release the dioke and
fast idle settings. If the throttle trigger is squeezed acci­
dentally during starting, it will be necessary to reset
throttle advance by pulling choke lever out fully.
• The choke provides additional fuel when starting a cold
engine.
• The choke is actuated by pulling the blue choke knob.
• The choke has two positions: off and full.
Figure 9
9
-