Replace fuel filter (fig. 33,34 & 35), Customer responsibilities – Craftsman 358.351080 User Manual
Page 21
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CUSTOMER RESPONSIBILITIES
REPLACE FUEL FILTER (Fig. 33,34 & 35)
The fuel filter should be replaced after each season. Never
operate your saw without a fuel filter. Be careful not to
damage fuel line while removing the fuel filter.
• Run fuel tank dry of fuel before proceeding with this step.
• Remove fuel cap and allow it to hang to side of motor.
• Using a small pair of needle nose pliers, grasp fuel cap
retainer, holding it in tank opening and pull out.
• With cap out of tank, use a small section of bent wire
similar to that shown in the illustration to catch fuel line
and slowly puli from tank. When fuel filter appears in
opening, grasp with fingers and remove from tank.
• Once filter is out of tank, hold fuel line dose to fuel filter.
Remove fuel filter by twisting arid pulling at the same
time.
• Replace fuel filter.
• Reverse process for installation.
Pliers
Fuel Cap
Retainer
/
Fuel RIter
Fuel Line Bgrrej
Filter Neck
Fuel Filter
Figure 35
2 1