Craftsman 315.214770 - Manual (Page 12)

I J
UNPACKING
This product requires assembly.
■ Carefully lift saw from the carton and place it on a level
work surface.
NOTE: This tool is heavy. To avoid back injury, lift with
your legs, not your back, and get help when needed.
■ Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
■ Do not discard the packing material until you have
carefully inspected and satisfactorily operated the tool.
■ The saw is factory set for accurate cutting. After
assembling it, check for accuracy. If shipping has
influenced the settings, refer to specific procedures
explained in this manual.
■ If any parts are damaged or missing, please call
1-800-932-3188 for assistance.
A WARNING: If any parts are missing, do not operate
this tool until the missing parts are replaced. Failure
to do so could result in possible serious personal
injury.
A WARNING: Do not attempt to modify this too!
or create accessories not recommended for use
with this tool. Any such alteration or modification is
misuse and could result in a hazardous condition
leading to possible serious personal injury.
A WARNING: Do not connect to power supply until
assembly is complete. Failure to comply could result
in accidental starting and possible serious persona!
injury.
MOUNTING THE SAW TABLE
See Figures 5 - 6.
A WARNING: Always make sure the band saw is
securely mounted to a workbench or an approved
work stand . Failure to heed this warning can result in
serious persona! injury.
■ Remove the angle adjustment knob from the side of
the saw housing.
NOTE: Take care when removing the nut and washer
from the center of the angle adjustment knob. There is
a spring in the center that is released after the nut and
washer are removed.
■ Remove the table aligning bolt, washer, and wing nut
from the saw table.
■ Standing at the front of the band saw, slide the saw
table through the slot moving from the right side of the
saw table to the left.
12