Craftsman 580.752000 - Manual (Page 6)

ASSEMBLY
Your pressure washer requires some assembly and is
ready for use oniy after it has been properly serviced
with the recommended oil and fuel.
If you have any problems with the assembly of
your pressure vtrasher, please call the pressure
washer helpline at
1-6D0 222-3136.
IMPORTANT: Any attempt to run the engine before it
has been serviced with the recommended oil will result
In an engine failure.
REMOVE PRESSURE WASHER
FROM CARTON
• Open carton and slice two corners opposite guide
handle from top to bottom so the panel can be
folded down flat.
• Remove fillers, accessories and parts bag shipped
with your pressure washer.
• Remove the pressure washer out the open end of
the carton.
• Check carton for additional loose parts.
CARTON CONTENTS
Check all contents. If any parts are missing or damaged,
call the pressure washer helpline at 1^00-222-3136.
• The main unit
• High pressure hose
• Spray gun
• Nozzle extension with adjustable nozzle
• Turbo wand
• Accessory holder
• Engine oil
• Parts bag (which includes items listed below)
Owner’s manual
Registration card
Become familiar with each piece before assembling
the pressure washer. Compare contents against the
view on page 5. If any parts are missing or damaged,
call the pressure washer helpline at 1-600-222-3138.
ASSEMBLING YOUR PRESSURE
WASHER
Your Craftsman pressure washer was mostly
assembled at the factory. However, you will need to
perform these tasks before you can operate your
pressure washer:
1. Add oil to engine crankcase.
2. Add fuel to fuel tank.
3. Connect high pressure hose to spray gun and
pump.
4. Connect water supply to pump.
Attach Accessory Holder
1. Place accessory holder onto top of handle.
2 . Place nozzle extension, turbo wand and spray gun
into holder.
IMPORTANT: Any attempt to crank or start the engine
before it has been properly serviced with the
recommended oil may result in an engine failure.
NOTE: When adding oil to the engine crankcase, use
only high quality detergent oil rated with API service
classification SF, SG, SH, SJ or higher rated SAE 30
weight. DO NOT use special additives.
1. Choose a viscosity according to the following table.
I
. . . . I. . . . . . . . .
äB :SB
ÜB
1BB !: f : : : : -ati : : : : : : : : : :a : : : : : : : : : : SB : : : : : Bii
fC.. -Xi ................. -Sf! ............-i(i................ B.............. ti)............... ai)............. si)...............4i)..
SmFTINi! TEVi-'EiWTURE RAMGE ANTIC"'A-ED BEFORE NEXT 0 L CHANGE
* The use of multi-viscKisity oils (5W-3C, 10W-30, etc.)
in temperatures above 40°F (4°C) will result in higher
than normal oil consumption. When using a multi­
viscosity oil, check oil more frequently.
*• If using SAE 30 oil in temperatures below 40°F
(4°C), it will result in hard starting and possible
engine bore damage due to inadequate lubrication.
Place pressure washer on a level surface.
Clean area around oil fill.
4. Remove oil fill cap and dipstick.
5. Wipe dipstick clean, insert it into oil fill hole and
tighten securely, remove dipstick. Add
recommended oil up to “FuH ' mark on dipstick.
2
.
3.