Craftsman 139.53918d - Manual (Page 36)

LCD Motion Detecting Control
Console Messages
The following messages are contained within the LCD
Motion Detecting Control Console and may appear
during the operations of the unit:
SAFETY SENSORS
CHECK ALIGNMENT,
BLOCKAGE OR
MISWIRING SEE
OWNER’S MANUAL
SAFETY SENSORS
MALFUNCTION
CHECK MISWIRING
SEE OWNER’S
MANUAL
LEARN REMOTE
CONTROL PRESS
LEARN BUTTON
TO CONFIRM
LEARN MODE PRESS
REMOTE CONTROL
BUTTON TO
PROGRAM REMOTE
LOCK MODE REMOTE
CONTROL LOCKED
OUT PRESS LOCK
BUTTON TO ENABLE
REMOTE
ENGLISH, FRANÇAIS
AND ESPAÑOL
MOTION SENSING ON
MOTION SENSING
OFF
Meaning: This message wiii appear if the Safety Reversing Sensors are out of
atignment, if they are biocked or if the wiring is disconnected. To dear message from
Controi Consoie do the foiiowing:
• Check to see that area is clear between the Safety Reversing Sensors.
• Check to see that the Safety Reversing Sensors are not misaligned.
• Realign receiving eye sensor, clean lens and secure brackets.
• Verify door track is firmly secured to wall and does not move.
• Check to see that the Safety Reversing Sensors’ wires are connected to the motor unit.
• If message has not cleared after the above checks, refer to message #2.
Meaning: This message wiii appear if the Safety Reversing Sensors are miswired.
To dear the message, do the foiiowing:
• Inspect the safety reversing sensor wires for a short (staple in wire), correct wiring
polarity (black/white wires reversed), replace/attach as needed.
• Disconnect all wires from back of motor unit.
• Remove safety reversing sensors from brackets and shorten sensor wires to 1-2 ft.
(30-60 cm) from back of each sensor.
• Reattach sending eye to motor unit using shortened wires. If sending eye indicator light
glows steadily, attach the receiving eye.
• Align sensors, if the indicator lights glow replace the wires for the sensors. If the sensor
indicator lights do not light, replace the safety reversing sensors.
Meaning: This message wiii appear when the ‘LEARN’button has been pressed on
the Controi Consoie. Pressing the ‘LEARN’ button again wiii aiiow the user to
program an additionai remote controi to the opener.
Meaning: This message wiii appear when the ‘LEARN’ button has been pressed a
second time on the Controi Consoie or anytime on the opener. The opener
is ready to program another remote controi by simpiy pressing the remote controi
button. Once the opener has ‘LEARNED’the remote controi, the workiight wiii biink
one time.
Meaning: This message wiii appear when the ‘LOCK’ button has been pressed and
heid for more than one second. This feature wiii disabie the opener from receiving
remote controi signais. To exit ‘LOCK’ mode, press and hoid the button
for more than one second.
Meaning: This message wiii appear when the ‘LANGUAGE’ button has been pressed.
Pressing the button wiii toggie to the next ianguage.
Meaning: This message wiii appear when the Motion Sensing button is pressed. The
motion detector wiii toggie on or off with each press of the button.
36