Craftsman 875.199810 - Manual (Page 7)

Owner’s Manual Model No. 875.199810
be a flexible hose in order to isolate
movement of the compressor.
Route the initial take-off line (pipe) as
straight up the shop wall and as high
as possible. This will help minimize
water leaving the compressor and
traveling through system
Slope the main lines down at least
3/4 inch per to feet of pipe away
from air compressor; this wiB draw
the condensate with the flow of air
and away from the compressor.
Place the first drop as far from the
compressor as the size of your shop
will allow (50 feel is optimal, although
unrealistic for a small shop). The
further the drop, the more that
condensation can occur, and the
drier the air will be when it reaches
the water separator.
In order to reduce the amount of
water and contaminants that get into
the water separator, install the take­
off line on the top of the main air
supply line for each air drop,
A Drain line should be placed at the
end of the main line for condensate
drainage.
Drain valves should be placed al the
end of branch lines and the drain
line, and drained daily.
Operation
This tools features a power regulator valve
(fig. 2). Rotate regulator until desired output
is achieved. The settings on the reguiator
are only for reference and do not denote a
specific power output. Turn regulator to
position with smaller circle being the least
amount of power and larger cirele being for
the most amount of power. The tool only
operates at maximum power in reverse.
Figure 2
Reguiator Valve
AWMWIWg
Ones s bolt or Issienor is seated,
Impacting for longer than five (5)
seconds will cause excessive wear and
possible damage to the Impacting
mechanism. If it takes longer than five
seconds to tighten or loosen your bolt
or fastener, we recommend the use of a
larger size impact wrench.
ENG-7