Craftsman 580.752010 - Manual (Page 4)

Keep water spray away from electric wiring or fatal
electric shock may result.
^ WARNING
M m
Runnina enaines produce
er an
can catch f
DO NOT touch hot surfaces.
Allow equipment to cool before touching.
The pressure washer must be at least 5 feet from
structures having combustible walls and/or other
combustible
materials.
Keep at least 3 feet of clearance on all sides of pressure
washer for adequate cooling, maintenance and servicing.
In the State of California a spark arrester is required by law
(Section 4442 of the California Public Resources Code).
Other states may have similar laws. Federal laws apply on
federal lands. If you equip the muffler with a spark arrester,
it must be maintained in effective working order.
4 WARNING
DO NOT wear loose clothing, jewelry or anything that
may be caught in starter or other rotating parts.
Tie up long hair and remove jewelry.
^ WARNING
WHEN ADJUSTING OR MAKING REPAIRS TO YOUR
PRESSURE WASHER
• Disconnect the spark plug wire from the spark plug and
place the wire where it cannot contact spark plug,
WHEN TESTING FOR ENGINE SPARK
• Use approved spark plug fester.
• DO NOT check for spark with spark plug removed.
^ WARNING
High pressure spray can cause paint cntps
Always wear eye protection when using equipment or when
in vicinity of equipment in use.
^ CAUTION
Excessively high or low operating speeds increase
risk of injury and damage to pressure washer.
DO NO I tamper with governed speed.
DO NOT operate pressure washer above rated pressure.
4^ CAUTION
A pressure washer produces a high pressure
which increases risk of injury and damage to unit.
DO NOT secure spray gun in open position,
DO NOT leave spray gun unattended while machine is
running,
NEVER use a spray gun which does not have a trigger
lock or trigger guard in place and in working order.
Always be certain spray gun, nozzles and accessories
are correctiy attached.
CAUTION
J
DO NOT point spray gun a! giass when in jet spray mode.
NEVER aim spray gun af piants.
CAUTION
improper treatment of pressur
damage it and shorten its life.
If you have questions about intended use, ask dealer or
contact Sears.
NEVER operate units with broken or missing parts, or
without protective housing or covers.
DO NOT by-pass any safety device on this machine.
Before starting pressure washer in cold weather, check
all parts of the equipment to be sure ice has not formed
there.
NEVER move machine by pulling on high pressure hose.
Use handle provided on unit.
Check fuel system for leaks or signs of deterioration,
such as chafed or spongy hose, loose or missing
damps, or damaged tank or cap. Correct all defects
before operating pressure washer.
This equipment is designed to be used with Sears
authorized parts ONLY, if equipment is used with parts
that DO NOT comply with minimum specifications, user
assumes all risks and liabilities.