Craftsman 944.514610 - Manual (Page 4)

Avoid dangerous situations. Do not
use in presence of flammable liquids
or gases to avoid creating a fire or
explosion and/or causing damage to
unit.
Avoid dangerous environments. Do
not use in unventilated areas or
where dust or explosive vapors can
build up.
To reduce the risk of electric shock,
the powerhead may have a polarized
plug (one blade is wider than the oth­
er); if so, it will require the use of a po­
larized extension cord. The appliance
plug will fit into a polarized extension
cord only one way. If the plug does
not fit fully into the extension cord, re­
verse the plug. If the plug still does
not fit, obtain a correct polarized ex­
tension cord. A polarized extension
cord will require the use of a polarized
wall outlet. This plug will fit into the po­
larized wall outlet only one way. If plug
does not fit fully into the wall outlet,
reverse the plug. If it stiil does not fit,
contact a qualified electrician to install
the proper wall outlet. Do not change
the equipment plug, extension cord
receptacle, or extension cord plug in
any way.
To reduce risk of electrical shock, use
extension cords specifically marked
as suitable for outdoor appliances
having electrical rating not less than
the rating of unit. Cord must be
marked with suffix “W-A” (in Canada
‘W’). Make sure your extension cord
is in good condition. Inspect extension
cord before use and replace if dam­
aged. Do not use a damaged cord.
Cord insulation must be intact with no
cracks or deterioration. Plug connec­
tors must be undamaged. The exten­
sion cord used to reach the power
source must be heavy enough to
carry current from the power source
the full length of the extension cord to
the unit. An undersized extension
cord will cause a drop in line voltage
resulting in loss of power and over­
heating. If in doubt, use the next
heavier gauge. The lower the gauge
number, the heavier the cord.
Do not use multiple cords.
Do not abuse cord. Never carry the
unit by the extension cord or yank
extension cord to disconnect unit. To
unplug, grasp the plug, not the cord.
Do not use cord as a handle, close a
door on cord, or pull cord around
sharp edges or corners. Do not ex­
pose cords to heat, oil, or water.
• Keep the extension cord clear of op­
erator and obstacles at all times.
• Tie cord to cord retainer and con­
nect to recessed plug as shown in
this manual to prevent damage to
unit and/or extension cord and to re­
duce the possibility of the extension
cord disconnecting from the unit dur­
ing operation.
• Do not attempt to repair unit. Inspect
the insulation and connectors on the
powerhead and extension cord before
each use. If there is any damage, do
not use until damage is repaired by
your authorized service dealer.
• Do not use the powerhead if the
switch does not turn the unit on and
off properly. Have the unit repaired
by your authorized service dealer.
• Do not use with damaged cord or
plug. If powerhead is not working as
it should, has been dropped, dam­
aged, left outdoors, or dropped into
water, return it to your authorized ser­
vice dealer for repair.
• Avoid unintentional starting of the
unit. Never carry unit with your finger
on the switch. Be sure the switch is
in the OFF position and never touch
the switch when connecting exten­
sion cord.
• Unplug the unit from the power
source when not in use, before servic­
ing, and when changing accessories
and/or attachments.
• Avoid any body contact with any
grounded conductor, such as metal
fences, or pipes, to avoid the possi­
bility of electric shock.
• Ground Fault Circuit Interrupter
(GFCI) protection should be pro­
vided on the circuit or outlet to be
used for the powerhead. Recep­
tacles are available having built-in
GFCi protection and may be used
for this measure of safety.
UNIT/MAINTENANCE SAFETY
WARNING;
Disconnect power-
head spark plug (or disconnect power-
head from power source) before per­
forming maintenance.
• Inspect entire unit before each use.
Replace damaged parts. Check for
fuel leaks. Make sure all fasteners are
in place and securely fastened.
• Maintain unit according to recom­
mended procedures.