Craftsman 917.272464 - Manual (Page 9)

INSTALL SEAT
Adjust seat before tightening adjustment
knob.
1. Remove adjustment knob and flat
washer securing seat to cardboard
packing and set aside for assembly of
seat to tractor.
2. Pivot seat upward and remove from
the cardboard packing. Remove the
cardboard packing and discard.
3. Place seat on seat pan so head of
shoulder bolts are positioned over the
large slotted holes in pan.
4. Push down on seat to engage
shoulder bolts in slots and pull seat
towards rear of tractor.
5. Pivot seat and pan forward and
assemble adjustment knob and flat
washer loosely. Do not tighten.
6. Lower seat into operating position and
sit in seat.
7. Slide seat until a comfortable position
is reached which allows you to press
clutchAjrake pedal all the way down.
8. Get off seat without moving its
adjusted position.
9. Raise seat and tighten adjustment
knob securely.
2
.
3.
4.
5.
NOTE: You may now roll or drive your
tractor off the skid. Follow the appropriate
instruction below to remove the tractor
from the skid.
TO ROLL TRACTOR OFF SKID (See
Operation section for location and
function of controis)
1. Press lift lever plunger and raise
attachment lift lever to its highest
position.
Release parking brake by depressing
ciutch/brake pedal.
Place freewheel control in ‘transmis­
sion disengaged” position (See ‘TO
TRANSPORT’ in the Operation
section of this manual).
Roll tractor forward off skid.
Remove banding holding deflector
shield up against tractor.
TO DRIVE TRACTOR OFF SKID (See
Operation section for location and
function of controls)
A WARNING: Before starting, read,
understand and follow all instructions in
the Operation section of this manual. Be
sure tractor is in a well-ventilated area. Be
sure the area in front of tractor is clear of
other people and objects.
I. Be sure ail the above assembly steps
have been completed.
Check engine oil level and fill fuel
tank with gasoline.
Place freewheel control in “transmis­
sion engaged" position. (See ‘TO
TRANSPORT’ in the Operation
section of this manual).
Sit on seat in operating position,
depress ciutch/brake pedal and set
the parking brake.
Place motion control iever in neutral
(N) position.
Press lift lever plunger and raise
attachment lift lever to its highest
position.
Start the engine. After engine has
started, move throttle control to idle
position.
Release parking brake.
Slowly move the motion control lever
forward and slowly drive tractor off
skid.
10. Apply brake to stop tractor, set parking
brake and place motion control lever
in neutral position.
II. Turn ignition key to "STOP" position.
Continue with the instructions that follow.
2 .
3.
4.
5.
6.
7.
8.
9.