beautypg.com

Storage, Tractor, Battery – Craftsman 917.272464 User Manual

Page 29: Other

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

STORAGE

Immediately prepare your tractor for

storage at the end of the season or if the
tractor will not be used for 30 days or

more.

^^WARNING: Never store the tractor
with gasoline in the tank inside a building
where fumes may reach an open flame or

spark. Allow the engine to cool before

storing in any enclosure.

TRACTOR

Remove mower from tractor for winter
storage. When mower is to be stored for
a period of time, clean it thoroughly,

remove all dirt, grease, leaves, etc. Store

in a clean, dry area.

1. Clean entire tractor (See “CLEANING”

in the Maintenance section of this
manual).

2. Inspect and replace belts, if necessary

(See belt replacement instructions in

the Senrice and Adjustments section
of this manual).

3. Lubricate as shown in the Mainte­

nance section of this manual.

4. Be sure that all nuts, bolts and screws

are securely fastened. Inspect moving
parts for damage, breakage and wear.

Replace if necessary.

5. Touch up all rusted or chipped paint

surfaces: sand lightly before painting.

BATTERY

• Fully charge the battery for storage.

• After a period of time in storage, battery

may require recharging.

• To help prevent corrosion and power

leakage during long periods of storage,
battery cables should be disconnected
and battery cleaned thoroughly (see

“TO CLEAN BATTERY AND TERMI­

NALS" in the Maintenance section of

this manual).

• After cleaning, leave cables discon­

nected and place cables where they

cannot come in contact with battery
terminals.

• If battery is removed from tractor for

storage, do not store battery directly on
concrete or damp surfaces.

ENGINE

FUEL SYSTEM
IMPORTANT: It is important to prevent

gum deposits from forming in essential
fuel system parts such as carburetor, fuel

hose, or tank during storage.

Also, alcohol blended fuels (called
gasohol or using ethanol or methanol)
can attract moisture which leads to
separation and formation of acids during
storage. Acidic gas can damage the fuel
system of an engine while in storage.

1. Drain the fuel tank.

2. Start the engine and let it run until the

fuel lines and carburetor are empty.

• Never use engine or carburetor cleaner

products in the fuel tank or permanent
damage may occur.

• Use fresh fuel next season.

NOTE: Fuel stabilizer is an acceptable
alternative in minimizing the formation of

fuel gum deposits during storage. Add

stabilizer to gasoline in fuel tank or
storage container. Always follow the mix
ratio found on stabilizer container. Run
engine at least 10 minutes after adding
stabilizer to allow the stabilizer to reach

the carburetor. Do not drain the gas tank

and carburetor if using fuel stabilizer.
ENGINE OIL
Drain oil (with engine warm) and replace
with clean engine oil. (See “ENGINE” in
the Maintenance section of this manual).
CYLINDER(S)

1. Remove spark plug(s).

2. Pour one ounce of oil through spark

plug hole(s) into cylinder(s).

3. Turn ignition key to start position for a

few seconds to distribute oil.

4. Replace with new spark plug(s).

OTHER

• Do not store gasoline from one season

to another.

• Replace your gasoline can if your can

starts to rust. Rust and/or dirt in your
gasoline will cause problems.

• If possible, store your tractor indoors

and cover it to give protection from dust
and dirt.

• Cover your tractor with a suitable

protective cover that does not retain
moisture. Do not use plastic. Plastic

cannot breathe which allows conden­

sation to form and will cause your

tractor to rust.

IMPORTANT: Never cover tractor while
engine and exhaust areas are still warm.

29