Craftsman 917.272464 - Manual (Page 26)

BELT INSTALLATION -
1 .
2 .
3.
4.
5.
6.
Carefully work new belt down around
transmission cooling fan and onto the
Input pulley.
Slide belt into the center span keeper.
Pull belt toward front of tractor and roll
around the top groove of engine
pulley.
Install belt through stationary idler and
clutching idler.
Make sure belt is in ail pulley grooves
and inside all belt guides and
[^00p0fg
Install mower (See ‘TO INSTALL
MOWER" in this section of manual).
LEVER NEUTRAL ADJUSTMENT
The motion control lever has been preset
at the factory and adjustment should not
be necessary.
Loosen adjustment bolt in front of the
right rear wheel, and lightly tighten.
Start engine and move motion control
lever until tractor does not move
forward or backward.
Hold motion control lever in that
position and turn engine off.
While holding motion control lever in
place, loosen the adjustment bolt.
Move motion control lever to the
neutral (N) (lock gate) position.
Tighten adjustment bolt securely.
1
.
2
.
3.
4.
5.
6
.
NOTE: If additional clearance is needed
to get to adjustment bolt, move mower
deck height to the lowest position.
After above adjustment is made, if the
tractor still creeps fon/vard or backward
while motion control lever is in neutral
position, follow these steps:
1. Loosen the adjustment bolt.
2. Move the motion control lever 1/4 to
1/2 inch in the direction it is trying to
creep.
3. Tighten adjustment bolt securely.
4. Start engine and test.
5. If tractor still creeps, repeat above
steps until satisfied.
Motion Control Lever Neutral
Lock Gate
26
Adjustment Bolt
TRANSMISSION REMOVAL/REPLACE-
MENT
Should your transmission require
removal for service or replacement, it
should be purged after re installation and
before operating the tractor. See “PURGE
TRANSMISSION" in the Operation
section of this manual.
TO ADJUST STEERING WHEEL ALIGN­
MENT
If steering wheel crossbars are not
horizontal (left to right) when wheels are
positioned straight forward, remove
steering wheel and reassemble with
crossbars horizontal. Tighten securely.
FRONT WHEEL TOE-IN/CAMBER
The front wheel toe-in and camber are
not adjustable on your tractor. If damage
has occurred to affect the front wheel toe-
in or camber, contact a Sears or other
qualified service center.
TO REMOVE WHEEL FOR REPAIRS
1. Block up axle securely.
2. Remove axle cover, retaining ring and
washers to allow wheel removal (rear
wheels have a square key - Do not
lose).
3. Repair tire and reassemble.
NOTE: On rear wheels only: align grooves
in rear wheel hub and axle. Insert square
key.
4. Replace washers and snap retaining
ring securely in axle groove.
5. Replace axle cover.