CLIFFORD AvantGuard II - Manual (Page 19)

Quick Programming Guide
Once you are familiar with the AvantGuard II programming procedures, you may
use this quick guide to make programming changes.
IMPORTANT: DO NOT use this guide unless you have programmed the
AvantGuard II before. If you have never programmed the system before,
you should refer first to the detailed programming instructions in the
appropriate section of How To Program Your AvantGuard II.
1. Turn ignition on, then, within 10 seconds, press and hold the valet/program
switch to its momentary side until you hear 1 chirp. The
LED will light, indicating the system is in program mode.
2. Select the feature you wish to program from the charts on
the following pages.
3. Flip the valet/program switch in the exact sequence and positions as noted on
the chart. Be sure to listen for the confirmation chirps where noted. (If you don’t
hear the indicated number of chirps, turn the ignition off and start over.)
4. If you wish to program another feature, perform the sequence for that feature.
Otherwise, turn the ignition off to exit program mode (you will hear 3 chirps
and the LED will turn off to confirm that the system has exited program mode).
Programmable
Feature
Parameter Action
Step Number
1 2 3 4 5 6 7 8 9 10 11 12 13 14
Smart
AutoArming
Enable
Flick switch to M L C M M M L C L
Number of chirps 1 3 3
Disable
Flick switch to M L C M M M L C M
Number of chirps 1 3 3
Entry delay
Flick switch to M M L C M M L C M 1 C
Number of chirps 2 2 1 3
Long-Term
Chirp Muting
Enable
(no chirps) Flick switch to M M L C M M M M L C M
Number of chirps 2 4 3
Disable
(normal chirps) Flick switch to M M L C M M M M L C L
Number of chirps 2 4 3
FACT
(False Alarm
Control
and Test
)
Enable
Flick switch to M M L C M L C L
Number of chirps 2 1 3
Disable
Flick switch to M M L C M L C M
Number of chirps 2 1 3
M = Momentary position L = Latched Position C = Center Position
1 Hold in momentary position for desired length of entry delay.
17