CLIFFORD AvantGuard II - Manual (Page 17)

How to Set the Smart AutoArming Entry Delay
Entry delay is programmable from 1 to 59 seconds (factory preset to 15 seconds). For
security reasons, the entry delay should be just enough time for you to open the door
and turn on the ignition. To set a new entry delay, use the following procedure:
1. Turn ignition to the ON position.
2. Within 10 seconds, press and hold the valet/program switch to its momentary
(spring-loaded) position until you hear 1 chirp, then release the switch. The LED
will light in red and stay lit, confirming that the system is now in program mode.
3. Tap the switch to its momentary position 2 times.
4. Flip the switch to its latched position, then back to center. You will hear 2
chirps.
5. Tap the switch to its momentary position 2 times.
6. Flip the switch to its latched position, then back to center. You will hear 2
chirps.
7. Press and hold the switch to its momentary position. You will hear 1 chirp.
Continue holding the switch for the desired entry delay, then release.
8. You will hear 3 chirps to confirm the new entry delay. Either proceed to step 3 of
the next feature you wish to program, or turn the ignition switch off to exit
program mode (you will hear 3 chirps and the LED will turn off to confirm that
the system has exited program mode).
How to Add a New Remote Control
Your AvantGuard II can function with as many as eight differently coded remote
controls. To add any type of Clifford remote control, use the following procedure:
1. Turn ignition to the ON position.
2. Within 10 seconds, press and hold the valet/program switch to its momentary
(spring-loaded) position until you hear 1 chirp, then release the switch. The LED
will light in red and stay lit, confirming that the system is now in program mode.
3. How to Program Button I/Channel 1: For arming/disarming the security system:
a. Tap the switch to its momentary position 3 times.
b. Flip the switch to its latched position, then back to center. You will hear 3
chirps.
c. Tap the switch to its momentary position 1 time.
d. Flip the switch to latched position, then back to center. You will hear 1 chirp.
e. With the switch in the center position, press button I on you remote control.
You will hear 3 chirps to confirm that the new button I code has been added.
f. To program button II/channel 2, go to step 4. Otherwise go to step 3 of the next
feature you wish to program, or turn the ignition off (you will hear 3 chirps
and the LED will turn off to confirm that the system has exited program mode).
4. How to Program Button II/Channel 2: For remote engine starting/shutdown:
a. Tap the switch to its momentary position 3 times.
15