Sony STR-D665 - Manual (Page 16)

Additional information
Specifications
Audio power specifications
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION
With 8-ohm load, both
channels driven, from 40 -
20,000 Hz, rated 100 watts
(STR-D665) or70W(STR-
D565) per channel minimum
RMS power, with no more
than 0.8 % total harmonic
distortion from 250 milliwatts
to rated output. (USA model
only)
Inputs Antenna Loop antenna
Amplifier section
Surround mode (8 ohms at 1 kHz, THD
0.9 %)
Front:
STR-D665: lOOW/ch
STR-D565: 60W/ch
Center:
STR-D665: lOOW/ch
STR-D565: 60W/ch
(only in the
DOLBY SUR
mode)
Rear: (4 ohms)
STR-D665: 30 W
STR-D565: 20 W
Dynamic power 8 ohms:
output
Harmonic
distortion at
rated output
Frequency
response
STR-D665:
150W + 150W
STR-D565:
95 W + 95 W
4 ohms:
STR-D665:
210W + 210W
STR-D565:
130W + 130W
Less than 0.8 %
PHONO: RIAA
equalization curve
±0.5 dB
CD, TAPE/MD, VIDEO:
10 Hz-50 kHz±l dB
Sensitivity Impedance S/N
(weighting
network,
input level)
PHONO 2.5 mV 50 74 dB
(MM) kilohms 72 dB*
(A, 2.5 mV)
CD STR-D665:
300 mV
STR-D565:
350 mV 50 82 dB
kilohms 82 dB*
TAPE/ STR-D665: (A, 250 mV)
MD,TV/ 200 mV
LD, STR-D565:
VIDEO 250 mV
Usable sensitivity 50 dB/m (at 1,000 kHz or
999 kHz)
S/N
Harmonic
distortion
Selectivity
54 dB (at 50 mV/m)
0.5 % (50 mV/m,
400 kHz)
At 9 kHz; 35 dB
At 10 kHz: 40 dB
» 78IHF
Outputs REC OUT VIDEO
(AUDIO) OUT:
Voltage 250 mV,
Impedance 10 kilohms
MIX OUT
Voltage; 2 V
Impedance: 10 kilohms
PHONES: Accepts low
and high impedance
headphones
* You can change the AM tuning interval
to 9 kHz. After tuning in any AM station,
turn off the receiver. Hold down the
PRESET TUNING + button and press the
POWER button. All preset stations will
be erased when you change the interval.
To reset the interval to 10 kHz, repeat the
procedure.
Video section
Inputs
Outputs
General
VIDEO, TV/LD:
1 Vp-p 75 ohms
VIDEO MONITOR:
1 Vp-p 75 ohms
16
Muting -20 dB
System Tuner section; PLL
+10 dB at 70 Hz
quartz-locked digital
BASS BOOST synthesizer system
Preamplifier section:
TONE ±8 dB at 100 Hz and Low-noise NF type
10 kHz equalizer
Power amplifier section;
FM tuner section Pure-complimentary
SEPP
Tuning range 87.5- 108.0 MHz
Power 120 VAC, 60 Hz
Antenna 75 ohms, unbalanced requirements
terminals 300 ohms, unbalanced
Power STR-D665:
Sensitivity Mono: 18.3 dBf, 4.5 )iV
Stereo: 38.3dBf,45MV consumption USA model: 186 W
Canada model: 290 VA
STR-D565:
Usable sensitivity 11.2dBf,2nV (IHF)
USA model: 170 W
Canada model: 195 W
S/N Mono: 76 dB
AC outlets 1 switched, total 120 W/
Stereo: 70 dB
lA Max
Harmonic Mono: 0.3 %
Dimensions 17 X 5 ^/s X11^/8 inches
distortion at Stereo: 0.5 % (430 X 135 X 295 mm)
1 kHz
Mass (Approx.) STR-D665: 7.2 kg
Separation 45 dB at 1 kHz (15 lb 14 oz)
STR-D565: 6.1 kg
Frequency 30 Hz - ]5kHz*!’'dB 03 lb 7 oz)
response
Supplied FM wire antenna (1)
Selectivity 60 liB at 400 kHz accessories AM loop antenna (1)
Remote controller
(remote) (1)
AM tuner section Size AA (R6) batteries (2)
Tuning range With 10 kHz interval**:
530- 1710 kHz Design and specifications are subject to
With 9 kHz interval: change without notice.
531 - 1710 kHz