Sony STR-D665 - Manual (Page 12)

12
Receiver Operations
3 PressMEMORY.
"MEMORY" appears for a few seconds.
Do steps 4 and 5 before "MEMORY" goes out.
4 Press SHIFT to select a character (A, B or C).
Each time you press SHIFT, the letter "A," "B" or
"C" appears in the display.
If "MEMORY" disappears, start again from step 3.
5 While MEMORY is displayed, press the number you
want to use (0 to 9).
6 Repeat Steps 2 to 5 to preset other stations.
To change a preset station
Preset a new station on the number you want to change.
Note
If the AC power cord is disconnected for more than one month,
the preset stations will be cleared from the receiver's memory,
and you will have to preset the stations again.
Tuning preset stations (preset tuning)
You can tune directly to a preset station by entering its
preset number. If you don't know which stations are
preset on which numbers, you can tune by scanning
the preset stations.
1 Press TUNER.
The last received station is tuned in.
Press SHIFT to select a character (A, B or C), then
press the number.
For example, select A and then press 7 to tune in the
station preset as A7.
■p'You can tune by scanning the preset stations
First press TUNER and then press PRESET TUNING + or
- to select the station you want. Each time you press the
buttons, the preset numbers change as follows:
• A) A2 >... -e—AO «-► B1 B2-e-» BO .
•CO*-» ... ---------------
Recording
This receiver makes it easy to record to and from the
components connected to the receiver. You don't have
to connect playback and recording components
directly: once you select a program source on the
receiver, you can record and edit as you normally
would using the controls on each component.
I
Before you begin, make sure you've connected all
components properly.
Function buttons
Recording on an audio tape or MiniDisc
You can record on a cassette tape or MiniDisc using the
receiver. See the instruction manual of your tape deck
or MD recorder if you need help.
Press one of the function buttons to select the
program source.
Set the component to be ready for playing.
For example, insert a CD into the CD player.
Insert a blank tape or disc into the recording deck
and adjust the recording level, if necessary.
4 Start recording on the recording deck and then start
playing the component.
Recording on a video tape
You can record from a TV or a LD player using the
receiver. You can also add audio from a variety of
audio sources when editing a video tape. See your VCR
or LD player's instruction manual if you need help.
1
2
Press TV-'/LD to select the program source.
Set the component to be ready for playing.
For example, insert the laser disc you want to record
from into the LD player.
3 Insert a blank video tape into the VCR for recording.
4 Start recording on the VCR and then start playing
the laser disc you want to record.
'Q' You can replace audio while copying a laser disc
.At the point you want to start adding different sound,
pro.ss another function button (for example, CD) and start
playback. The sound troni the selccteci component will be
recorded over the original audio.
To resume recording the sound of the laser disc, press the
TV/LD function button.