Installation instructions, Note – Sony MRD-D1 User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Installation Instructions
1
Make certain that your present system is functioning correctly
prior to installing MRD-Dl. Ensure that all antenna or cable
signals are being received on all TVs that will be connected to
MRD-Dl.
2
Determine whether your home TV service is cable (CATV) or off-
air (anterma).
Note
• You should make written notes on this step so that you can refer to
them later.
□ If cable: determine the highest charmel number delivering a
-^cture signal, excluding channels 95-99. If uncertain, contact
your local cable company.
□ If antenna: time the TV one channel at a time from channel 14
to channel 36. Write down the channel number of each channel
that has no trace of a picture.
3
Deternune which of the remote TVs will be provided with IR
control capability using the IR target provided with MRD-Dl.
Note
• You can, at a later time, move the target to another remote TV, or add
more IR targets. For now, you need to plan where the target will be
used.
4
Select an installation location for the modulator unit that satisfies
all of the following conditions:
□
□
□
□
is close to the DSS receiver and the second video source;
has 110 volt AC power within easy access;
can connect easily to the coaxial input that delivers either the
antenna or cable signal to the main TV;
permits connection of the IR emitters to the video sources
within the length of the emitter cable (6 ft.);
is clean and dry and likely to stay that way. Mounting near
window or door openings is strongly discouraged.
Installation Instructions