Sony MRD-D1 - Manual (Page 12)

Note
• INPUT 2 must be higher than INPUT 1 when using CATV channels,
and INPUT 1 and INPUT 2 must be separated by at least one unused
channel.
• If the MRD-Dl is improperly tuned, the power indicator will blink. Do
not ignore a blinking power indicator even if the TV is showing a
picture. Repeat the tuning procedure until the power indicator is
steady on.
4
Tune your TV to the channel you selected for INPUT 1. Turn on
the DSS receiver.
5
Using the tuning tool provided, turn the first two rotary controls
on the top of the modulator unit to the channel number selected in
step 3. Begin the tuning process by setting the first digit of the
channel with the first rotary control, and then the second digit of
the charmel with the second rotary control. Tune only one channel
at a time.
MODULATOR
\
LINE 1 LINE 2
%
3
J
When the channel is selected, the main TV should be displaying a
picture. This confirms proper operation and channel tuning. The
DSS channel will now be available on every TV connected to the
system.
Repeat steps 4 and 5 using your second video source and your
selected INPUT 2 number. If there is no second source, set INPUT 1.
12 Installation Instructions