Sony SS-RC301 - Manual (Page 12)

Receiver Operations
1 Press one of the Function buttons to select the
component you want to use.
The Function buttons on the remote are factory-
set as follows;
To listen to or watch Press
Radio programs TUNER
Compact discs (CD) CD
MiniDiscs (MD) or
audio tapes
MD/TAPE
(INITIAL-MD MODE)
TV programs TV
VHS Video tapes
(VTR-3 mode) VIDEO
DVD Player/AC-3
decoder 5.1 CH
If you want to change the factory setting of a
button, see the next section.
The receiver and the selected component turn on.
ff the component does not turn on
Press the power switch on the component.
2 Start playing.
Refer to "Remote Button Descriptions" on page 25
for details.
To turn off the components
Press SYSTEM STANDBY. You can turn off the video and
audio components connected to the SWITCHED AC
OUTLET at the same time.
Note
Press SYSTEM STANDBY together with the TUNER button
to set SYSTEM STANDBY switch to turn only the receiver on
or off. Press SYSTEM STANDBY together with the 5.1 CH
button to return the SYSTEM STANDBY switch to normal
operation.
Changing the factory setting of a
function button
If the factory settings of the FUNCTION buttons
don't match your system components, you can change
them. For example, if you have two CD players and
you don't have a tape deck or an MD recorder, you can
assign the MD/TAPE button to your second CD
player.
Note that the settings of the TUNER button cannot be
changed.
Numeric buttons -
CD CD
o
CD CD CD
CD CD CD
o o o
o o o
o o o
olofo
Function
buttons
1 Hold down the Function button whose function
you want to change (MD/TAPE, for example).
2 Press the corresponding numeric button of the
component you want to assign to the Function
button (1 - CD player, for example).
The numeric buttons are assigned to select the
functions as follows:
Numeric button Operates
1 CD player
2 DAT deck
3 MD deck
4 Tape deck A
5 Tape deck B
6 LD player
7 VCR (remote control mode VTR 1*)
8 VCR (remote control mode VTR 2*)
9 VCR (remote control mode VTR 3*)
0 TV
>10 SAT
Enter DVD
Sony VCRs are operated with a VTR 1, 2 or 3 setting.
These correspond to Beta, 8mm and VHS respectively.
Now you can use the MD/TAPE button to control
a second CD player.
12
To reset the setting to the factory setting
Repeat the above procedure.