Sony CDP-CX240 - Manual (Page 6)

Getting Started
Connecting Another CD Player
(CDP-CX240 only)
If you have a Sony CD player equipped with the
CONTROL A1 jack and the command mode of that
player can be set to CD 3, you can control that player as
the second^layer with this unit. After cormecting this
unit and an amplifier, follow the procedure below.
Be sure to turn off the power of each player before
making this connection.
To LINE OUT
COMMAND
I—^ : Signal flow To an AC outlet
What cords will I need?
♦ Audio cord (1) (Use the cord supplied with the player to be
connected.)
• Monaural (2P) mini-plug cord (1) (not supplied)
1
Coimect the players with an audio cord (see also
"Hookups" on page 5).
CDP-CX240
CDP-CX200, etc.
2
Connect the players with a monaural (2P) mini­
plug cord.
CDP-CX240 CDP-CX200, etc.
For details on this connection, refer to the
supplementary "S-Link™/ CONTROL-Al Control
System" instructions.
3
Set the COMMAND MODE selector of each
player.
Set the COMMAND MODE selector of this player
to CD 1 or CD 2, and set that of the second player
to CD 3.
COMIMNO MOPE
ÜÜ
For details on how to operate the second player,
see "Controlling Another CD Player" on page 20
and "Playing Alternately" on page 22.
4 Connect the AC power cord of both players to AC
outlets.
Notes
• Do not connect a player other than that you use as the
second player to the 2ND CD IN jacks of this player.
• When connecting a second CD player, do not connect the
DIGITAL OUT (OPTICAL) connector of this urut to the
amplifier.