Sony TC-WE435 - Manual (Page 5)

Playing a Tape
3 2 4
See page 4 for hookup
information.
You can use either deck for
playback.
'Q* To play a tape recorded
with the Dolby* NR
Set DOLBY NR to the same
position that the tape was
recorded in—B or C.
What is the Dolby NR?
The Dolby NR (noise
reduction) eliminates tape
hiss noise by boosting low-
level signals in the high-
frequency range during
recording, then lowering
them during playback. Type
C provides greater noise
reduction than type B.
y You can connect the
headphones to the PHONES
jack
"DOLBY", the double-D
symbol DO and "HX Pro" are
trademarks of Dolby
Laboratories Licensing
Corporation.
1 Turn on the amplifier and select the tape deck position.
Press ©, and press = fully to open
the cassette holder, then insert a
cassette.
With the side you want to play
facing you
Set DIRECTION MODE.
To play back Set to
One side only
Both sides continuously*
Both decks in succession* RELAY
* The deck automatically stops after playing back five times.
Press C>.
The deck starts playing. Adjust the volume on the amplifier.
Do not turn off the deck during operation.
To Press
Stop playing ■
Start playback from the reverse side <3
Pause (deck B only) PAUSE II. Press the button again to
resume play.
Fast-forward or rewind ►►or<^
Take out the cassette = after stopping playing
C*' To adjust the pitch (Pitch Control function)
ON Push in the PITCH CONTROl. button to activate the Pitch Control
^ (Q function and turn the control clockwise to raise the pitch or
'of^jpOi- counterclockwise to lower it.
You can adjust the pitch during playback (
-•(f \\\ speed dubbing.
; on deck A or normal-