Sony CDP-CX300 - Manual (Page 6)

Getting Started
Connecting Another CD Player
(CDP-CX300/CX333ES only)
If you have a Sony CD player in which 5,50, 200, or
300 discs can be inserted and which is equipped with
the CONTROL A1 H (or CONTROL Al) jack and the
command mode of that player can be set to CD 3, you
can control that player as the second player with this
unit. After connecting this unit and an amplifier, follow
the procedure below.
Be sure to turn off the power of each player before
making this connection.
What cords will I need?
• Audio cord (1) (U.so the cord supplied with the player to be
connected. )
• Monaural (2P) mini-plug cord (1) (not supplied)
1 Connect the players with an audio cord (see also
"Hookups" on page 5).
CDP-CX230, etc.
2 Connect the players with a monaural (2P) mini­
plug cord.
CDP-CX300/CX333ES CDP-CX230, etc.
For details on this connection, refer to the
supplementary "CONTROL Al n Control
System" instructions.
3 Set the COMMAND MODE selector of this player
to CD 1 or CD 2, and set the command mode of the
second player to CD 3.
COMMAND MODS
ae
For details on how to operate the second player,
see "Controlling Another CD Player" on page 21
and "Playing Alternately" on page 23.
4 Connect the AC power cord of both players to AC
outlets.
Notes
• Do not connect a player other than that you intend to use as
the second player to the 2ND CD IN jacks of this player.
♦ When connecting a second CD player, do not connect the
DIGITAL OUT (OPTICAL) connector of this unit to the
amplifier.