Sony CDP-CX300 - Manual (Page 21)

Playing CDs
Controlling Another CD Player
(Advanced Mega Control)
This unit can control a second CD player (see
"Connecting Another CD Player" on page 6).
Even when a second CD player is connected, the
controls on both of the units will function. When you
press the play button on either unit, the operating
player stops and the resting player starts.
Make sure "2nd DETECTED" appears in this player's
display after turning on both players.
Note that depending on the player, you may not be
able to operate all the functions of the second CD
player.
The controls indicated in the illustration below are effective
while the MEGA CONTROL button is lit.
Play mode buttons
(CONTINUE/SHUFFLE/
PROGRAM/REPEAT) KM AMS >C>11 MENU/NO JOG
Press MEGA CONTROL on this player.
The MEGA CONTROL button and "2nd" in the
display light up. The display shows the current
disc number or disc memo of the second player.
2nd DISC
J c D I S C - 4 t
Current disc number or the Disc Memo
2 Select the desired play mode.
To program tracks, use the controls on the second
player.
3 Press O on this player to start playing.
The play starts and the display shows the current
disc, track numbers, and the playing time of the
track.
While the MEGA CONTROL button is lit, you can
control the second player with the controls on this
player.
To control the master player again
Press MEGA CONTROL. The MEGA CONTROL button goes
off and you can control the master player.
To control the second player directly using the supplied
remote d
Set CD 1 / 2 / 3 on the remote to CD 3 which is the same
position as the COMMAND MODE selector on the rear panel
of the second player.
21