Sony CDP-CX300 - Manual (Page 33)

Additional Information
Troubleshooting
If you experience any of the following difficulties while
using the player, use this troubleshooting guide to help
you remedy the problem. Should any problem persist,
consult your nearest Sony dealer.
There is no sound.
■^Check that the player is connected securely.
^Make sure you operate the amplifier correctly.
The CD does not play.
^There is no CD in a slot ("-NO DISC-"
appears).
Insert a CD.
^Insert the CD with the label side facing right.
^Clean the CD (see page 32).
^Moisture has condensed inside the player. Open
the front cover and leave the player turned on
for about an hour (see page 32).
The remote does not function.
^Remove obstacles in the path of the remote and
the player.
^Point the remote at the remote sensor B on the
player.
^Replace all the batteries in the remote with new
ones if they are weak.
^Set the CD 1 / 2 / 3 switch on the remote
according to the position of the COMMAND
MODE selector displayed in the front panel.
display (see page 5).
The player functions incorrectly.
^The microcomputer chips may be operating
incorrectly. Disconnect the AC power cord, then
connect it back to the wall outlet to reset the
player.
Specifications
Compact disc player
Laser Semiconductor laser (X = 780 nm)
Emission duration: continuous
Laser output Max 44.6 pW*
* This output is the value measured at
a distance of 200 mm from the
objective lens surface on the Optical
Pick-up block with 7 mm aperture.
Frequency response 20 Hz to 20 kHz ±0.5 dB
SIgnal-to-noise ratio CDP-CX333ES: More than 110 dB
CDP-CX300 / CX691: More than 107 dB
Dynamic range CDP-CX333ES: More than 95 dB
CDP-CX300/CX691: More than 93 dB
Harmonic distortion CDP-CX333ES: Less than 0.003 %
CDP-CX300/CX691: Less than 0.0045 %
Channel separation More than 100 dB
Outputs
Jack
type Maximum Load impedance
output
level
LINE OUT Phono
jacks
2 V Over 10 kilohms
(at 50 kilohms)
DIGITAL OUT Optical
(OPTICAL) output
connector
-18 dBm Wavelength: 660 nm
General
Power requirements 120 V AC, 60
Hz
Power consumption CDP-CX333ES: 17 W
CDP-CX300/CX691: 13 W
Dimensions (approx.)'
(w/h/d) 430 X 189 X 464 mm (17 x 7 1 /2 x 19 in.)
incl. projecting parts
Mass (approx.) CDP-CX333ES: 9.0 kg (19 lbs 14 oz)
CDP-CX300/CX691: 8.5 kg (18 lbs 12 oz)
Supplied accessories
See page 4.
Design and specificationsare subject to change without notice.
33