Sony CDP-C40 - Manual (Page 15)

Maintenance Specifications
Cleaning the cabinet
Clean the cabinet, panel and controls with a soft cloth lightly
moistened with mild detergent solution. Do not use any type
of abrasive pad, scouring powder or solvent such as alcohol
or benzine.
Cleaning discs
Before playing, clean the disc with the cleaning cloth. Wipe
the disc from the center out.
COMPACT DISC PLAYER
Do not use solvents such as benzine, thinner, commercially
available cleaners or anti-static spray intended for analog
discs.
After playing, store the disc in its case.
System
Laser
Laser output
Wow and (lutter
Outputs
Compact disc digital audio system
Semiconductor laser = 780 nm)
Emission duration: continuous
Max. 44.6
m W*
* This output Is the value measured at a d ¡stance ol
about 200 mm from the obiect ive lens surface on the
Optical Pick-up Block.
Frequency response
2 Hz-20 kHz (±0.5 dB)
Signal to noise ratio
More than 100 dB
Dynam ic range More than 88 d B
Harmonic distortion
Less than 0.05% (1 kHz)
Channel separation
More than 95 dB (1 kHz)
Below measurable limit
LINE CUT (phono jacks)
Cutput level 2 V (at 50 kilohms)
Load impedance over 10 kilohms
HEADPHCNES (stereo phone jack)
(CDP-C50only)
Culput level 0 - 2.4 mW (variable)
(at 32 ohms)
General
Power requirements
120 VAC, 60 Hz
Power consumption
12W
Dimensions Approx, 430 x 110 x 385 mm (w/h/d)
(17 x4Y»x 151/4 inches)
not Including projecting parts and controls
Weight Approx. 5.7 kg (12 lbs 10 oz), net
REMOTE COMMANDER {supplied only for the CDP-CSO)
Remote control system
Infrared control
Power requirements
3 V DC with two size AA (R6) batteries
Dimensions Approx. 61 x 20 x 150 mm (w/h/d)
( 21/2 xi3/,tx 6 inches)
Weight Approx. 110 g (4 oz)
Including batteries
SUPPLIED ACCESSORIES
Audio signal connecting cord
(phono plug X 2*-*phono plug x 2) (1)
CDP-CSO only:
Sony SUM-3 (NS) batteries (2)
Design and specifications subject to change without notice.