Sony CDP-C40 - Manual (Page 10)

Programming Selections Using the
Remote Commander of the Sony Stereo
System
You can play up to 32 selections in the desired order.
1
Press PGM.
2
Press D. SELECT (disc skip) to move the disc tray.
3
Choose the selection by pressing K4 or ^#4.
(To choose a whole disc, press and then
4
Press PGM again.
5
To program additional selections on a same disc,
repeat steps 3 and 4.
To program additional selection on another disc,
repeat steps 2,3 and 4.
To program a whole disc under a single program
number
Simply press the DISC SELECT button which corresponds to
the disc you want. The TRACK indicator will show R , which
means that all the selections on the disc have been
programmed under a single program number.
To program shuffle play
Press SHUFFLE PLAY when adding an entire disc to your
program. All the selections on that disc will be played in
random order. Shuffle play will not affect the other selections
in your program. SHUFFLE PLAY cannot be used while a
program is being played. (See page 15.)
The program will be cleared in the following
situations
• ■ is pressed during stop.
• ± is pressed during program play.
• Power is turned off.
To play the programmed selections
Press ► (or ► II on the main unit).
To return to nonmal play mode
Press PGM again.
Skipping to the next selection programmed
Press during play.
Going back to the beginning of the selection being played
Press HM during play.
To play a selection not included in the program
Press PGM again. PGM will disappear and you can then play
another selection on a disc. This operation does not clear the
programmed selections, and you can resume program play by
pressing ■, PGM, and then
To stop program play
Press ■. The last selection number programmed will be
displayed.
To resume play, press ►. Play begins from the beginning of the
program.