Specifications, Audio power specifications, Power output and total harmonic distortion – Sony STR-D515 User Manual
Page 21: Video section, Other specifications, Amplifier section, Tuner section, General, For usa and canadian models)
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Specifications
(For USA and Canadian models)
Audio Power Specifications
POWER OUTPUT AND TOTAL HARMONIC DISTORTION
With 8-ohnn load, both channels
driven, from 40 - 20,000 Hz, rated 100
watts (STR-D615) or 70 watts (STR-
D515) per channel minimum RMS
power, with less than 0.8% total
harmonic distortion from 250
milliwatts to rated output.
SUR (surround) MODE (8 ohms, less than 0.8% total harmonic
distortion)
Video section
STR-D615
STR-D515
FRONT
70 W pier channel
70 W per channel
CENTER (only in the
DOLBY mode)
70 W
20 W
REAR (Spk. Parallel
use)
20 W
20 W
Other Specifications
Amplifier section
Continuous RMS power output (8 ohms, at 40 Hz - 20 kHz less than
0.8% total harmonic distortion)
STR-D615:100 W + 100 W (FRONT)
STR-D515: 70 W + 70 W
Dynamic power (at 1 kHz IHF) (FRONT)
STR-D615; 140 W + 140 W (8 ohms), 210 W + 210 W (4 ohms)
STR-D515; 95 W + 95 W (8 ohms), 140 W + 140 W (4 ohms)
Harmonic distortion
Less than 0.8% at rated output
Frequency response
PHONO: RIAA equalization curve ±0.5 dB
CD -|
VIDEO
10 Hz - 50 kHz ±1 dB
TAPE
-I
Inputs
Sensitivity
Impedance
S/N (weighting
network, mputlevel)
PHONO
2.5 mV
50 kilohms
75 dB (A)
75 dB* (A, 5.0 mV)
CD
300 mV
50 kilohms
82dB(A)
82 dB» (A, 500 mV)
VIDEO,
TV/LD
TAPE/MD
250 mV
»'78 IHF
Outputs
REC OUT, VIDEO
(AUDIO) OUT
Voltage 250 mV
Imjjedance 10 kilohms
HEADPHONES
Accepts low and high impedance
headphones
Tone controls
BASS; ±8 dB at 100 Hz
TREBLE:+8 dB at 10 kHz
Muting
-20 dB
LOW BOOST
+10 dB at 70 Hz
INPUT
VIDEO,
TV/LD
1 Vp-p 75 ohms
OUTPUT
VIDEO
MONITOR
1 Vp-p 75 ohms
Tuner section
FM tuner section
AM tuner section
Tuning range
87.5 —108 MHz
530 -1710 kHz
(10 kHz step)»»
531 -1710 kHz
(9 kHz step)
Anterma
terminals
300 ohms,balanced
75 ohms, unbalanced
External anterma
terminal
Sensitivity at
50 dB quieting
18.3 dBf, 4.5 pV (mono)
38.3 dBf, 45 pV (stereo)
—
Usable
sensitivity
11.2 dBf, 2 pV (IHF)
Loop antenna:
500 pV (at 1,000 kHz)
Signal-to-noise
ratio
76 dB (mono)
70 dB (stereo)
54 dB (at 50 mV/m)
Harmonic
distortion
0.3% (mono), 0.5%
(stereo) at 1 kHz
0.5%(at50mV/m,
400 Hz)
Selectivity
60 dB at 400 kHz
40 dB at 10 kHz
Separation
45 dB at 1 kHz
—
Frequency
response
30 Hz —15 kHz
»0^ dB
-2
—
General
System
Tuner section: PLL quartz-locked digital
synthesizer system
Preamplifier section: low-noise NF type equalizer amp
Power amplifier section: pure complementary SEPP
Power requirements
120 V AC, 60 Hz
Power consumption
U.S.A. model: 186 W (STR-D615)
170W(STR-D515)
Canadian model: 290 VA (STR-D615)
195 W (STR-D515)
AC outlet
One switched (120 W/IA Max.)
Dimensions
Approx. 430
X
135
X
295 mm (w/h/d)
(17 X 5 ’/j X11 ’/j inches)
including projecting parts and controls
Mass
Approx. 7.2 kg (16 lb 2 oz) (STR-D615)
Approx. 6.3 kg (13 lb 15 oz) (STR-D515)
Accessories supplied
FM wire antenna (1)
AM loop antenna (1)
Remote Commander RM-U242 (1)
Sony batteries SUM-3(NS) (2)
Design and specifications are subject to change without notice.
*» For the models in U.S.A. and Canada
You can change the AM tuning interval to 9 kHz. After tuning in
any AM tuning in any AM station, turn off the power of receiver
once. While holding down the TUNING + button, press the
POWER switch. When you change the interval, all the preset
stations will be erased. To reset the interval, repeat the same
procedure.
^ ,|