Editing a video source – Sony STR- D915 User Manual

Page 18

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

I Chapter 3 Advanced Operations

Recording an Audio Source

Editing a Video Source

Recording on a Tape

You can record and make copies of audio program sources

on a tape, DAT or MD using the receiver. See your tape
deck, DAT deck or MD recorder’s instruction manual if you
need help.

¡■yrgsfcir V ■■

-m-iv.-i

■=t> Audio signal flow

1 Press a function button to select the

recording source.

Set the recording source to be ready for

playback.
For example, tune in the desired station for an FM/
AM broadcast.

Insert a blank tape into the recording deck

and adjust the recording level, if necessary.

Start recording on the recording deck and

then start playing the recording source.

Note
When you record on a DAT deck or MD recorder coimected
to the DAT/MD RFC OUT jacks, the sound field and low

boost settings have no effect on recording.

You can monitor the sound being recorded on a

tape

If you have connected a 3-head tape deck to the TAPE
MONITOR jacks, press TAPE MONITOR while recording or

dubbing, so that the TAPE MONITOR indicator lights up
and you can monitor the recording results. To listen to the
source sound, press the button again until the indicator goes

off.

Recording on a Video Tape

You can record and make copies of programs from other
VCR, LD player or TV using the receiver. See your VCR, LD
player or TV’s instruction manual if you need help.

’ Signal flow

STR-D915 only

Press a function button to select the

recording source.

Set the recording source to be ready for
playback.
For example, insert a source tape you want to record
from into the playback VCR.

Insert a blank video tape into the recording

VCR.

start recording on the recording VCR and

then start playing the recording source.