Casio EXILIM EX-Z16 - Manual (Page 17)

17
Quick Start Basics
3.
With your computer
turned on, connect the
camera to it.
Charging will start at
this time.
The back lamp will light red
while charging is in
progress and go out after
charging is complete. It
takes about 170 minutes to
achieve a full charge.
Charging may take longer
depending on charging
conditions.
Back Lamp Operation
4.
After charging is complete, disconnect the USB cable from the camera
and then from the computer.
IMPORTANT!
• Charging is not performed when connected to the USB port of a printer, TV, etc.
• Charging will not start whenever the battery temperature is 0°C (32°F) or below or
60°C (140°F) or above.
• Charging is not performed while the connected computer is in the hibernate mode.
• Depending on the setup of your computer, you may not be able to charge the
camera’s battery over a USB connection. If this happens, use of the charger that
comes with the camera is recommended.
• A charging error can occur immediately after charging begins or some time after
charging begins. A charging error is indicated by the back lamp flashing red.
Lamp Status Description
Lit Red Charging
Flashing Red
Abnormal ambient temperature,
charging taking abnormally long,
or battery problem (page 126)
Off Charging complete
USB port
USB cable
(included with camera)
Making sure that the mark on the USB cable
connector is towards the lens side, connect the cable
to the camera.
USB/AV port
Large connector
Small connector
Back lamp