Casio EXILIM EX-Z16 - Manual (Page 126)

126
Appendix
.
If the charger’s [CHARGE] lamp flashes red...
• Charging cannot be performed because ambient temperature or the temperature of
the charger is too hot or too cold. Leave the camera in a location whose
temperature is within the range where charging can be performed. When the
camera returns to a temperature where charging can be performed, the [CHARGE]
lamp will light red.
• Check if the charger and battery contacts are dirty. If contacts are dirty, wipe them
clean with a dry cloth.
.
If the camera’s back lamp starts flashing red while charging over
the USB cable...
• Ambient temperature or the temperature of the battery may be either too high or
too low. Disconnect the USB cable and wait until temperature is within the
allowable charging range before trying again.
• Battery contacts may be dirty. Wipe them with a dry cloth.
• Try connecting to a different computer USB port. Depending on the setup of your
computer, you may not be able to charge the camera’s battery over a USB
connection.
1.
Open the battery cover and
remove the current battery.
With the monitor screen side of the
camera facing upwards, slide the
stopper in the direction indicated by
the arrow in the illustration. After the
battery pops out, pull it the rest of
the way out of the camera.
2.
Load a new battery.
Power Supply
Charging
If problems continue to occur after you perform the above steps, it could mean that
the battery is faulty. Contact your nearest CASIO authorized service center.
To replace the battery
Stopper