Sony CDP-391 - Manual (Page 15)

Maintenance
Locating the Portion with the Largest Volume^
- Peak Search O
You can locate the portion with the highest input level to
adjust the recording level.
Before starting play, press PEAK SEARCH.
“PEAK” appears In the window and starts blinking as the
peak search begins functioning. It takes time for the unit to
carry out the jDeak seach. On completing the search, the unit
starts repeating the portion with the peak volume.
While the unit is repeating the peak portion
- Press ►!! (or II) to enter the unit into the pause mode at
the beginning of the first selection.
- Press ► (on the remote commander) to start play from the
first selection.
To cancel the peak search
Press ■. “PEAK” disappears from the window.
Note
During program mode, the peak search will not function if
nothing is programmed.
Cleaning Your Unit
Clean the cabinet, panel and controls with a soft cloth lightly
moistened with a mild detergent solution. Do not use any
type of abrasive pad, scouring powder or solvent such as
alcohol or benzine.
Cleaning Discs
When a disc becomes dirty, clean it with a cleaning cloth.
Wipe the disc from the center out.
On peak search
The unit scans input levels of the whole CD and
determines the peak (maximum input level) among them.
The peak determined with this function is sometimes
slightly different from the real one. In addition, portions
determined as a peak may vary each time this function is
carried out even on the same CD. The difference
between the determined and the real peak is, however,
negligible enough for you to adjust the recording level.
Do not use solvents such as benzine, thinner, commercially
available cleaners or anti-static spray intended for analog
discs.
If you press PEAK SEARCH before delete shuffle or program
play
The unit scans the input levels of the chosen selections only.
15