Sony CDP-391 - Manual (Page 11)

To stop playing
Press ■.
You can play the same program repeatedly as long as you
do not cancel program play or erase the program.
To cancel the program play
Press CONTINUE and enter the unit into the normal playing
mode.
The program will be erased.
To erase the entire program
Press ■ once during stop; twice during play.
The program is also erased when you press ^ or turn off the
unit.
To check your program
Press CHECK. The first selection in the program will be
displayed. When CHECK is pressed during play, the
selection being played is displayed.
Each time you press CHECK, the next selection in the
program will be displayed. The tape indicator, at this time,
will show you which side of the tape these selections have
been programmed into.
After the last selection, “End” will be indicated and the
display will soon return to the initial status in one second.
To change your program______________________
You can make the following changes before starting play.
To make a program for editing a tape
You can divide your program into programs A and B by
inserting a pause between them. Use this function to make a
program for both sides of the tape at one time.
To erase the last selection, press CLEAR.
Each time you press CLEAR, the last selection in the
program will be erased.
To add a selection to the end of the program, just
press the numeric button for that selection. You can
add a selection also during play or pause.
1 Program the selections for program A.
2 Press II on the remote commander. “B” in the tape
indicator and “P” will be displayed in the window and the
total playing time will be reset to 0.
3 Program the selections for program B.
When you start playing the selections, program A will be
played and then the unit will pause with the chosen
selections for program B lighted in the window. Set the tape
to the beginning of side B, then press ►!! (► or
II). The
selections for program B will be played.
To delete a selection, press CHECK repeatedly until
the undesired selection is displayed. Then press CLEAR.
To change the order, press ■ during stop to erase the
program. Then repeat the programming procedure from the
beginning.
If is displayed instead of the the actual time
- you have programmed a selection number over 20.
- the total time is more than 100 minutes.
To check the number of programmed selections
Press TIME during the stop mode. The number of programmed
selections will be displayed in the window.
What is the tape indicator ?
During program play, the tape indicator shows you which side of the
tape is being played.
: Side A is being played.
Side A has been played and the unit is in the pause
mode, or side B is being played.
To check the remaining time
Press TIME once to see the remaining time of the selection being
played; twice to see the total remaining time; once more to return to
the initial display.
If you have divided the program into A and B by inserting a pause
between them, the display shows the remaining time until the pause.
If you have programmed a selection number over 20, is
displayed instead of the actual time.
11