Sony CDP-391 - Manual (Page 12)

Designating the Totai Piaying Time
- Time Edit
You can designate a time and the unit wili make 2 different programs of selections each fitting within that period. Use this
function, by designating the iength of your tape, for editing both sides of a tape.
1
0 Designate the time required for recording. *
TIME SET
EDIT/TIME FADE
c
EDIT
Press EDIT/TIME FADE once
more, to make a program for
the other side of your tape.
“B" in the tape indicator stops
blinking to light, and “EDIT”
disappears from the window.
Chosen selections
Designated duration
23.00 ^ 27.00 -> 30.00
I------- ^ 45.00 ^ 37.00
__________, I,
0
Hih SEC [BIT [ 1 2 3 4 5
PHÜQflAw] 1_______ J
Total time
To adjust the second
Pressing ◄◄/►*
time by 10 second intervals.
(or ◄◄/►►) allows you to adjust the
To play the program
Press ►II (or^).
The selections for side A will be played and then the unit will
pause. Set the tape to the beginning of side B, then press
►II (► or II). The selections for side B will be played.
To check or erase the program and to stop or cancel
the play_______________________________________
See the preceding page.
To include desired selections in the program_____
1 Make your own program of the desired selections.
See page 10 for instructions.
2 Follow the above procedure.
Just designate the length of your tape; you need not
subtract the length of your program. The unit will place
your selections at the beginning of its program and add
other selections to fit the remaining time.
If your disc has more than 20 selections
Selections over number 20 cannot be programmed with the time edit
function; use the programming procedure on page 10.
To designate a different time for each side
Execute steps 1 to 4, then execute steps 3 and 4 for the other side.
12