Sony STR-D590 - Manual (Page 9)

Remote Commander
[U Receiver control section
FUNCTION
PHONO, TUNER, CD, TAPE, DAT , VIDEO 1, VIDEO 2:
When each function Is selected, the unit enters Its
operating mode automatically,
SYSTEM OFF: Turns off the power of the whole system.
POWER: Turns on the power of the receiver.
SOUND FIELD buttons
MODE: Selects the surround mode,
ON/OFF: Turns on/off the surround system.
REAR LEVEL +h buttons: Control the volume of rear
speakers (surround level).
DELAY button: Adjusts the delay time.
DBFS button: Turns on/off the DBFB (Dynamic Bass
Feed Back).
MUTING button: Mutes the sound.
MASTER VOL +/- buttons: Control the receiver
volume.
[2] Other equipment control section
The operative buttons are changed according to the
function mode and the setting of the SYSTEM/TV
selector.
Numeric buttons (1 to 0): Designate the number,
ENTER: Press after designating the TV/VCR channel.
SHIFT: Select the memory page (A, B or C).
TV/VIDEO selector: Selects the program to see ; TV or
VCR,
ANT TV/VTR button: Selects the output signal from the
antenna terminal on the VCR, either a TV signal or
VCR programs.
CH/PRESET +/“ buttons: Select a preset channel.
■«/►►: Fast winding/Manual search
• and ►: Forward recording
• and Reverse recording
Play
■: Stop
II: Pause
« 1 : Locates a desired selection.
D (disc) SKIP: Disc skip (for a CD player equipped
with a multi-disc changer)
SELECT: Changes the settings of the FUNCTION button.
[3] SYSTEM/TV mode switch
In TV mode (When setting the SYSTEM/TV selector to
TV.)
Only MUTING, MASTER VOL -r/- and the operative
buttons in TV section on the list described on the next
page can be used.
Inserting the Batteries into the Remote
Commander
Before operating remote commander, install the batteries as
shown below.
To avoid damage caused by battery leakage and
corrosion
When the commander will not be used for a long time,
remove the batteries.
Battery life
Normal operation can be expected about a half year using
Sony SUM-3 (NS), and a year using Sony AM-3 (NW)
alkaline batteries.
When the batteries are run down, the remote commander
will not operate the unit. In this case, replace batteries with
new ones.
9