Sony STR-D590 - Manual (Page 4)

Precautions
I Chapter 1 Getting Started |
Unpacking
On safety
• Operate the unit only on 120 V AC, 60 Hz.
• For U.K, model, operate the unit only on 240 V AC,
50/60 Hz.
• Should any solid object or liquid fall into the cabinet,
unplug the unit and have it checked by qualified
personnel before operating it any further.
• Unplug the unit from the wall outlet if it is not to be used
for an extended period of time. To disconnect the cord,
pull it out by grasping the plug. Never pull the cord itself.
• One blade of the plug is wider than the other for the
purpose of safety and will fit into the power outlet only
one way. If you are unable to insert the plug fully into the
outlet, contact your dealer, (not apply for U.K. customer)
• AC power cord must be changed only at the qualified
service shop.
• This unit is not disconnected from the AC power source as
long as it is connected to the mains outlet, even if the unit
itself has been turned off,
Choosing a Good Location
To prevent internal heat buildup in the unit,
place the unit in a location with adequate air circulation.
Do not install the unit:
• near heat sources such as radiators or air ducts.
• in a place subject to direct sunlight, excessive dust,
mechanical vibration or shock.
Do not place anything on top of the cabinet.
The top ventilation holes must be unobstructed for the
proper operation of the unit and to prolong the life of its
components.
Do not throw away the carton and packing material!
It will be an ideal container when transporting the system for
repair work, etc.
On operation
Before making program source connections, be sure to
turn the power switch off and unplug the unit.
On cleaning the cabinet
Clean the cabinet, panel and controls with a soft cloth lightly
moistened with mild detergent solution. Do not use any type
of abrasive pad, scouring powder, or solvent such as
alcohol or benzine.
Checking the Supplied Accessories
After unpacking, check that the following accessories are
present,
• FM wire antenna................................................................(1)
• AM loop antenna............................................................... (1)
• Remote commander RM-U222......................................... (1)
• Sony batteries SUM-3
(NS)........................................... (2)
For the customers in the U.S.A.
For detailed safety precautions, see the “IMPORTANT
SAFEGUARDS" leaflet.
Selecting the AM Tuning Interval (Except U.K.
model)
If you have any question or problem concerning your unit,
please consult your nearest Sony dealer.
The AM tuning interval is preset to 10 kHz, To use the
receiver where the frequency allocation system is based on
a 9 kHz interval, make the following adjustments.
1 Turn on the power and tune in any AM station.
2 Turn off the power,
3 Press the POWER button while pressing the "-i-" TUNING
button.
To reset the AM tuning interval, repeat the above steps.
Caution
When the interval is changed, all preset stations which you
have memorized will be erased. After changing the interval,
be sure to preset the stations again.