Sony CDP-C331 - Manual (Page 13)

To program a whole disc
• Using DISC 1 to 5
Alter steps 1 and 2: ,
1 Press DISC 1 to 5 to select the disc.
“AL” is displayed on the display.
® a
0 I
1 I L
i 9 4 $
e r • « 10
. . ^ 13 M ts
a-
( 1 ) 0 9 4
O f
tIL
C C U C
DO,
14-)
5 M
1 3 3 4 »
0 r a 9 •
It 11 13 M IS
2 Go on to step 5.
• Using DISC SKIP
After steps 1 and 2;
1 Press DISC SKIP. “AL” is displayed on the display.
2 Press PROGRAM.
3 Go on to step 5.
The whole disc is programmed as one. step.
To program while observing the disp labels
You can program the selections with the disc tray open.
To play the selections for side B
When the selections for side A have been played, the unit
will pause. (“B” lights up.)
Set the tape to the beginning of side B, then press ^ or
II.
The selections for side B will start playback.
To stop program play
Press ■. The last selection number programmed will be
displayed.
To resume playback, press Play begins from the
beginning of the program.
You can play the same program repeatedly as long as you
do not cancel program play or erase the program.
To cancel program play
Press CONTINUE and return to the continuous playback
mode. The program will be erased.
Skipping to the next selection programmed
Press bM during playback.
Going back to the beginning of the selection being
played
Press Md during playback.
To cancel all the selections programmed
Press ■ to cancel.
Notes
• The playing time for selection numbers higher than 20 will not
be added into the total playing time.
• When selections have been programmed fpr sides A and B, the
total playing time displayed in stop mode will show the
selections programmed for side B and the btal playing time for
^de B.
I
13