Sony ICF-SW7600 - Manual (Page 10)

Manual Tuning—if yo
the frequency of a desired station
Scan Tuning
------ To have a station scanned automatically
1 Set POWER/LOCK to POWER.
2 Press ON/OFF.
The radio is turned on.
3 Press MANUAL TUNING (+ or -) repeatedly while
keeping BAND pressed to search for the
approximate frequency of a desired station.
The lowest frequency of each band or the meter band
of SW appears iri the display.
If you keep MANUAL TUNING pressed, the band
changes continuously.
4 Press MANUAL TUNING (+ or -) repeatedly to
search for a desired station.
'.iei. --------- it. -------...j
To prevent accidental change of the receiving station
Press KEY PROTECT. The mark appears in the display window and all
the buttons on the front panel will not work.
To release the KEY PROTECT function, press KEY PROTECT again.
When the station is tuned in
The TUNE indicator lights up.
Frequency band changes continuously
If you keep MANUAL TUNING ( + ) pressed, the frequency band being tuned
in will change from LW to MW. SW, FM and then back to LW.
What is meter band?
SW is devided into 13 bands by the wave length (meter).
Each band is called meter band (see page #).
4
t
i
НП
-p
1 Set POWER/LOCK to POWER.
2 Press ON/OFF.
3 Receive a broadcast band by pressing MANUAL
TUNING while keeping BAND pressed, or by pressing
PRESET/DIRECT TUNING. (Refer to the table on the
right page for the frequency range of each broadcast
band.)
4 Press SCAN TUNING START/STOP.
Within the frequency range of the table on page #,
scan tuning will begin and stop automatically for 1.5
seconds when a station is received and then the
tuning indicator lights up.
5 Press SCAN TUNING START/STOP again to listen to
the station being received.
e Tune in the station more precisely by MANUAL
TUNING (+ or -), if necessary.