Tri-Tronics G2 Pro Control™ RL - Manual (Page 7)

Troubleshooting Guide
Problem #1. The receiver did not accept a set.
Be sure the receiver has been turned on, and that
you press the transmitter button within
five
seconds of pressing the SET switch. Waiting
longer than five seconds will cause the receiver
to return to normal on mode. Make sure receiver
batteries are charged.
Problem #2. I press the transmitter button
but my training device does not activate.
A. Be sure that the receiver is turned on.
B. Check your transmitter dial and select
the correct number for that receiver. (You
can use the sound button to confirm your
setting and that the receiver is turned on.)
C. Be sure you are using the correct transmitter.
D. Be sure you have plugged your training
device into the receiver. Use the TEST
switch to confirm.
E. Be sure you are pressing the correct
transmitter button for the output jack
you used for the training device.
F. Check that you have set up your training
device correctly, and that any “safety” or
“on” switch on the training device itself is
set to allow activation.
G. Be sure that neither the transmitter nor
receiver batteries have run down.
H. If you are a very long way from the
training device, range could be the problem.
(You can use the sound button to confirm
that the receiver is getting your transmitter
signal.) Maximize your range by holding the
transmitter straight overhead when you press
the button. You can also improve range by
raising the receiver higher off the ground,
and by pointing its antenna straight up.
I. There may be a malfunction in your training
device itself. If you cannot resolve
the problem, contact its manufacturer.
Problem #3. My training device is plugged
into the receiver, but the TEST light does
not light.
Be sure the receiver is turned on and its batteries
are charged.
The TEST light only lights up while the TEST
switch is pressed.
If it is still not lighting, there may be a failure in
the wiring of your training device. Contact the
manufacturer of the training device if you can't
resolve the problem.