Tri-Tronics G2 Pro Control™ RL - Manual (Page 2)

The Pro Control™ RL
Please read these instructions before using
your Pro Control™ RL
The Pro Control™ RL controls a variety of remotely
operated dog training equipment, including:
• Several brands of bird releasers used
for training pointing and flushing dogs
• Most brands of launchers used for
retriever training
• Several accessory items for retriever
launchers such as “retiring guns”
and sound-making devices
Quick Guide
1. Charge the receiver approximately 14 hours
before first use (the transmitter has a 9-volt
battery already installed – no need to charge).
Insert the protection plug in the charging jack
of the receiver after charging.
2. Attach the antennas (long antenna on the
receiver, short antenna on the transmitter)
and attach the transmitter lanyard, if desired.
3. Field-set the receiver as follows:
A. Select the transmitter dial number you
want to use when you operate this receiver.
B. Turn the receiver on by pressing the
on/off switch – the on light will blink.
C. Press the SET switch on the receiver,
and, within five seconds, press any button
on the transmitter.
D. Verify your setting, if desired, by pressing
the yellow transmitter button. Be sure to
put your hand over the horn – it's loud!
E. Attach the identification number
to the receiver, if desired.
4. Attach the receiver to your training
device according to the manufacturer's directions.
5. Plug the cord from the training device
into either output jack on the receiver.
Insert the protection plug in the unused
output jack.
6. The red transmitter button operates the
training device plugged into the left output jack
The green transmitter button operates the
training device plugged into the right output
jack. The yellow button operates the sound .
7. You can set up two training devices close
to each other and operate them with one
receiver by using both output jacks. If both
training device cords won't reach the receiver,
an extension cord can be purchased from
Tri-Tronics.
8. Pressing the TEST switch on the receiver
verifies the hook-up of your training
devices by lighting the appropriate light
on the receiver.
9. Turn the receiver off after use by pressing
the on/off switch again. The setting will
be saved.
10. To change the station setting of the
receiver, set it to a new transmitter number
by following Step 3.