Tri-Tronics G2 Pro Control™ RL - Manual (Page 4)

the corresponding jack. Pressing the TEST
button will not activate training devices.
Transmitter Buttons
To operate the device plugged into the left output
jack, press the red button on the transmitter.
To operate the device plugged into the right output
jack, press the green button on the transmitter.
The small yellow transmitter button operates
the receiver sound (see the next section).
Sound
The speaker on the receiver makes a loud sound
when the yellow button on the transmitter is
pressed. This sound can be used to attract a
retriever's attention to a mark or to help the trainer
locate a launcher hidden in heavy cover. When a
very loud sound is desired for training retrievers at
field trial distances, place the receiver in a way that
orients the speaker toward the “line.” For more
about the sound feature, see “Sound Selection.”
CAUTION: The speaker is very loud – do not
operate it close to a person unless you place
something over the speaker to muffle the sound.
Turning the Receiver On and Off
Press the on/off switch on the receiver to turn
it on. (This step is the equivalent of inserting the
“turn-on plug” in our 150 System.) The red light
on the receiver will light up when the receiver
has been turned on, and then blink twice every
four seconds (if it flashes rapidly, this means the
receiver battery is low).
When not using the system, turn the receiver
off to save battery life.
Press the on/off switch to turn the receiver
off – the red light will make one long flash then
go dark, confirming that the receiver is off.
Setting the Receiver to the Transmitter
Before you can use a Pro Control™ RL receiver
for the first time, you must set it to operate with
your transmitter.
If you have several receivers, set each one
to a different transmitter dial number.
Follow these steps to set the receiver to match
a particular number on the transmitter dial.
1. Turn the receiver on.
2. Set the transmitter dial to the number you
want to use to operate that receiver (1-7).
3. Press the SET switch – the red on/off
light will glow for about five seconds.
4. Press any of the three transmitter
buttons during the 5-second period.
The receiver light will blink once to
confirm that your setting took effect.
5. If you want to verify that your setting
took effect, muffle the speaker with your
hand and press the yellow sound button
on the transmitter.
Note that the field-setting instructions are on the
label on the bottom of the Pro Control™ RL receiver.