SOLIS Swiss Perfection HE - Manual (Page 27)

27
CLEANING YOUR DRYER
Before cleaning, disconnect the appliance from the mains. Never immerse the appliance in water.
Please remember to clean the air intake slot regularly with a brush to remove dust and hair from the
air inlet grill. You can clean your appliance with a slightly damp cloth and dry it with a soft cloth.
DETACHABLE AIR INLET GRID
The hairdryer is fitted with a detachable air-inlet grid. To free the appliance of sucked-in hair and dust,
remove the air inlet grid by rotating it slightly to the left. The air inlet grid can be cleaned with e.g. a
brush. When cleaning is finished, rotate the air-inlet grid back onto the hairdryer by rotating to the right.
The filter must never under any circumstances be replaced when wet. Never use the
hairdryer without air inlet grid attached. Regular cleaning will significantly prolong the service life of
your hairdryer.
OVERHEATING PROTECTION
The appliance is equipped with a safety thermostat. lt will switch itself off automatically if it overheats.
After a short cooling-down period, the appliance will come back on again automatically. Always check
that the air intake and outlet points are completely unobstructed.
Appliance is
switched off
Motor runs fast
Heat level: hot
Motor runs fast
Heat level: warm
Motor runs
slowly
Heat level: hot Motor runs
slowly
Heat level: warm
Motor runs fast
Heat level: max.
HOW TO OPERATE
The two rocker switches can be used to select the following settings:
Solis_SwissPerfection-Typ443-Betriebsanleitung.indd 27 10.05.12 16:17