Scilogex MS-Pro - Manual (Page 11)

9
MS-(H)-Pro Digital（Hotplate）Magnetic Stirrer
Operation mode B
●
MS-Pro maintains the state of the heating and stirring
functions before the last switching off (mains OFF), as well
as the data set last can be changed.
●
Remote control can be used.
●
Stirring bar breakaway monitoring can’t be set in this
mode.
Note:
Mode changing and parameter setting is forbidden
when the instrument is running.
Switch OFF “Stir”and “Heat”control knob
in advance before change mode.
8 Function: Heating(MS-H-Pro)
The device is controlled by Digital Temperature Control
Technology ,which has two separate safe circuit. The
hotplate is kept at a constant temperature by a digital control
circuit. The hotplate temperature can also be monitored from
a separate, adjustable safety circuit. The two temperature
sensors (Pt1000) internal for temperature control are built
into the hotplate.The single external Pt1000 can monitor the
temperature of sample.
If external temperature sensors needed, it must be plugged in
before the device is switched ON.
• Ensure the external temperature sensors connecting
firmly before heating.
• Set the temperature via turnning the temperature control
knob slowly to the ideal scale .
• When the heating function is switched on, the LED
“
Heat” will light up and the LCD will display the real
temperature.
• The rated temperature will be displayed on the right-hand
side of the LCD as well as Temp and °C characters.
• The heating function is switched on or off via pushing the
heat knob.
8.1 Working with external temperature sensor
Figure 5