Schiit Lyr 2 - Manual (Page 5)

3 Gain Switch. Up is
high gain, for hard-to
drive, inefficient head-
phones. Low provides
lower gain and lower
noise for efficient
headphones.
3 On-Off Switch. Up
is on. Down is off. For
best tube life, turn Lyr
off when you’re not
using it for a while.
1 RCA Inputs.
Connect to your music
source here. You can
even use fancy cables
if you like.
2 Preamp Outputs.
Connect to powered
monitors or a speaker
amp. Preamp outs are
muted on first turn-on
and when headphones
are plugged in.
4 AC Input. Plug the
power cord in here.
Plug the other end into
an outlet of the correct
voltage. Trying to run
a 115V Lyr on 230V
will blow the fuse and
generally make for a
bad, bad day.
5 Disclaimer. No,
seriously. Don’t take
this apart. Don’t stick
paperclips through
the holes on the top
or side. There are
seriously dangerous
voltages inside, and we
don’t want you to die.
REAR CONNECTIONS
03.200101
1 2 3 4
5
lyr 2 manual.indd 5 4/10/14 2:33 PM