Schiit Lyr 2 - Manual (Page 3)

IN THE bOX
Lyr 2 accomodates any 6DJ8, 6922, ECC88,
6N23P, 6BZ7, and 6N1P tube types, so feel free
to swap the stock tubes to “tune” the overall
sound signature to your needs.
To swap tubes:
1. Turn off and unplug the amplifier. Wait a few
minutes for the tubes to cool.
2. Carefully extract tubes by gently rocking them
back and forth and pulling upwards. Yes, we
know it’s a pain in the kiester. Have patience, or
ask a friend with small hands to help.
3. Carefully insert the replacement tubes. Align
the pins to the sockets and press down gently
until the tubes are seated.
4. Plug the amplifier back in and turn it on. After
the tubes warm up, you should hear music.
Follow this same procedure when replacing
tubes that are worn out from use. Tubes last
about 5,000 hours typically.
CAUTION! Dangerous voltages inside.
Follow all instructions carefully.
1. Before plugging in the amplifier, insert the
tubes. They’re both the same, so it doesn’t
matter where they go.
2. Ensure tubes are well-seated. Align carefully
and push down gently until seated.
3. Plug in your amplifier and turn it on. The
tubes will glow after a few seconds, and the
relay will connect the output after 20 seconds.
4. Connect your source. And enjoy your music!
TUBES
gETTINg STARTED TUbE SWAPPINg
lyr 2 manual.indd 3 4/10/14 2:33 PM