Seizing method ii – Samson DOUBLE BRAID Class II Tips for Stripping the Cover User Manual

Page 4

PAGE 4 OF 4

SamsonRope.com

| Email

| Tel

+1.360.384.4669

Seizing Method ii

S a M S O n S P L i c i n g i n S T r U c T i O n S

S T E p 1

Attach twine to netting needle.

S T E p 4

Continue with this procedure until the whipped area is approximately

1/2 of the desired length, then cut off the taped end near the last wrap.

S T E p 3

Start seizing. Wrap the needle around the circumference of

the rope 1 complete turn. Pass the netting needle under the

complete wrap left to right. Pull the loop tight. Pull the needle

up maintaining tension on the completed half hitch and then

quickly pull back down to lock the half hitch in place.

S T E p 2

Tape the free end of the twine to the

opposite side of the area to be whipped.

twine

tape

Cut taped end off

1 2 3 4 5 6 7 8 9 10 11 12

S T E p 5

Using some spare twine, tape a loop that covers the length

of the intended whipping distance, letting the 2 free ends

of the looped twine lay over the completed whipping.

Tape the free ends of the loop past the already

whipped area.

S T E p 6

Continue whipping for the desired total length over the top

of the looped twine. After whipping is complete, pass the

exposed whipping twine through the loop. Remove the tape

on the looped twine and pull the ends to draw the loop under

the whipping. Cut off any excess twine.

S T E p 7

Pull the loop through the whipped area. This should place

the remaining whipping twine under the whipped area.

Continue whipping

over top of loop

Pass exposed

twine through loop

DOCUMENT Double_Braid_C2_Stripping_Cover.pdf

S/WD #108294 7/2012