Samson 12-STRAND Class II Tuck-Bury End-for-End Splice - Manual (Page 3)

PAGE 3 OF 3
SamsonRope.com | Email [email protected] | Tel +1.360.384.4669
12-Strand Class II Tuck-Bury End-For-End Splice
S A M S O N S P L I C I N G I N S T R U C T I O N S
6
step
Tuck the strands from Rope A into Rope B. 1 complete tuck consists of passing a
strand over 1 strand and under 2 strands.
Do 3 complete tucks for all 6 strands. Each strand is always tucked under the same
line of the braid so that the tucks progress straight down the body of the rope.
After completing the first 3 tucks, remove half the volume of the twisted yarns from
each of the 6 strands near the taped ends, and complete 3 more tucks with the
reduced-volume strands.
z
s
s
s
z
z
z
s
s
z
t u c K i n g t h e s t r a n d s
z
s
s
z
z
s
z
s
7
step
After completing the second set of 3 tucks, cut off the excess material
and tape the ends. Leave enough of an end protruding so it does not
slip back into the rope when the rope is loaded.
Follow Steps 5 and 6 until all tails are tucked.
Your finished Tuck-Bury End-for-End Splice will look like this:
f i n i s h i n g t h e s p l i c e
Finished splice
DOCUMENT 12Strand_C2_Tuck-Bury_End_For_End.pdf
© 2012 Samson Rope Technologies, Inc. All rights reserved. S/WD #108294 7/2012