Roadi RDT40 - Manual (Page 16)

OWNER S MANUAL
,
OBD2 CODE READER
16
" " --A flashing Rig ht Arrow Indicating additional information is
available on the next screen.
" " --A flashing Left Arrow Indicating additional information is available
on the previous screen.
1) Select "3. I/M"”from the main menu by pressing the
ENTER button.
some states, one or more such monitors may be allowed to be“"Not
Ready" to pass the emissions inspection.
"YES"”--All monitors supported on the vehicle have completed their
diagnostic testing and the MIL lig ht is not on.
"NO"--At least one monitor supported on the vehicle has not completed
its diagnostic testing, and (or) the Check Engine ( MIL) lig ht is on.
"READY"--indicates that a particular monitor being checked has
completed its diagnostic testing;
"Not RDY(NOT READY)"--indicates a particular monitor being checked
has not completed its diagnostic testing;
"N/A"--The monitor is not supported on that vehicle.
Menu:
3. I/M
If the Scan Tool is not connected yet, then refer to
" Reading Codes"
from 1 to 6. at Paragraph 4.1.
2) Use the
SCROLL button to view the status of the MIL light ("ON" or
"OFF") and the following monitors:
MISFIRE"--Misfire monitor
FUEL--Fuel System Monitor
CCM--Comprehensive Components Monitor
EGR--EGR System Monitor
O2S--O2 Sensors Monitor
AT--Catalyst Monitor