Rega Aria - Manual (Page 6)

3
BACK PANEL / CONNECTIVITY
Setup
Separate inputs are used for moving magnet and moving coil cartridges. Connect
your turntable’s tonearm cable to the appropriate input sockets on the back of the
Aria. If your tonearm has a separate earth this should be firmly connected to the
earth terminal shown on the rear panel in the diagram above.
Connect the Aria to your amplifier via the sockets marked Output to the
appropriate line level input on the back of your amplifier. Use a high quality phono
cable such as the Rega Couple 2 (not supplied). The mains power lead (supplied)
should be connected to the IEC socket on the right hand side located above the fuse
holder.
NB. Always switch both pre and power amps off before changing any connections.