Rega RP10 - Manual (Page 15)

Do not use any polish on the turntable or lid. To clean, wipe gently with a soft cotton
duster (slightly damp only if required).
Rega turntables are designed to optimise performance for music reproduction and
therefore no compromises have been made to give quick start times. The normal time
taken for full speed to be reached is between 2 and 5 seconds.
Warning: Any attempt to repair or modify the turntable or tonearm by persons other
than Rega approved personnel may invalidate the guarantee. Should you experience any
problem with your turntable, please contact your Rega dealer.
TRANSPORTING YOUR RP10
Should you need to transport your RP10, to avoid any possible transit damage, the
following recommendations must be followed. Remove the balance weight from the
tonearm and secure the arm tube in its rest with tape or covered wire. This will ensure
no sudden or violent movement is transmitted to the delicate bearings. To remove the
platter, hold down the hub centre at the same time as lifting the platter on each side.
NEVER place your RP10 upside-down or on its side. This would allow oil in the
hub/bearing assembly to leak and cause speed and/or wear problems. If you have to
ship your turntable or use a carrier, save and use ALL of the original packaging.
12
RP10 English Manual Text_Apollo English manual.qxd 17/12/2013 15:28 Page 14