Rega RP10 - Manual (Page 12)

9
CONNECTING THE RP10 CUSTOM POWER SUPPLY
Connect the XLR interconnect between the
power supply and the turntable’s AC input
terminal in the back of the RP10 PSU. Switch the mains power on. To minimise the risk
of hum pick up by the cartridge, the power supply should be situated as far from the
turntable as the interconnect cable will allow.
Push the power button on the front panel to turn the RP10 PSU on - When the power
supply is switched on, the Rega logo will illuminate RED,
Press the 33rpm button to activate 33rpm or 45rpm to activate 45rpm from the front
panel.
SPEED PROGRAM AND SPEED ADJUSTMENT (FACTORY SET)
Adjustments on the rear panel are factory set. It is not recommended to attempt any
adjustment as each turntable is optimsed for peak performance. Attempting to adjust
these settings without the correct test equipment could seriously effect the
performance of your turntable and could place the drive belts and motor under
unnecessary strain.
CONNECTION TO THE AMPLIFIER
The tonearm external phono leads must be connected to your amplifier’s phono stage
or an indepedent phono stage such as the Rega Aria switchable MM/MC stage.
Connect as follows : Red right channel / Black left channel. If your amplifier does not
have an integrated phono stage you will require an external stage (sold separately).
RP10 English Manual Text_Apollo English manual.qxd 17/12/2013 15:28 Page 11